Filter
Top Products
36
www.pridemobility.com Legend
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your scooter are designed to help you perform basic troubleshooting quickly and easily.
A diagnostic flash code will flash from the status LED in the event one of the conditions listed below develops.
NOTE: Your scooter will not run unless the flash code condition is resolved and the scooter has been
turned off, then turned back on.
XI. BASIC TROUBLESHOOTING
What if all the systems on my scooter seem to be dead?
n Make certain that the key is in the on position.
n Check that the batteries are fully charged. See VI. Batteries and Charging.
n Push in the main circuit breaker reset button. See V. Your Legend.
n Make certain that both battery harnesses are firmly connected to the rear electronics module and to the battery
terminals. See IX. Disassembly and Assembly.
n Make sure that the front-to-rear harness is firmly connected to the rear electronics module. See IX. Disas-
sembly and Assembly.
n Check the 3-amp fuse located on the lower portion of the tiller console. See XII. Care and Maintenance for
fuse replacement.
n Be sure the Power Down Timer feature feature hasnt been activated.
What if my scooter does not move when I press the throttle control levers?
n When the manual freewheel lever is pulled up, the brakes are disengaged and all power to the motor/transaxle assembly is cut.
n Push down on the manual freewheel lever, turn the scooter off, and then turn the scooter on to return to normal
scooter operation.
FLASH CODE
CONDITION SOLUTION
(1)
Batteries are too low to operate the
scooter or the charger is operating.
Charge batteries or unplug the charger power cord
from the electrical outlet.
(2) Motor disconnected. Check all connections to the motor.
(3) Motor wiring fault. Call your authorized Pride Provider for assistance.
(6)
Scooter is operating with the charger
attached.
Unplug the charger power cord from the charger powe
r
cord receptacle.
(7) Throttle potentiometer fault. Call your authorized Pride Provider for assistance.
(8) Internal controller fault. Call your authorized Pride Provider for assistance.
(9)
Brake fault—your scooter was left in
freewheel mode.
Turn the scooter key to the off position, then push the
manual freewheel lever to the (down) drive position
,
and restart your scooter.
(10)
High battery voltage. The batteries have
been overcharged and the scooter won’t
run.
Leave the scooter turned on to
drain the batteries to a
sufficient level. If the batteries continue to overcharg
e
call your authorized Pride Provider for assistance.