Filter
Top Products
34
www.pridemobility.com Legend
I X . DISASSEMBLY AND ASSEMBLY
ASSEMBLY
1. Position the front and rear sections of your scooter as
shown in figure 21.
2. Align the lower slots of the front section with the cor-
responding pegs on the front of the rear section.
3. Holding the seat post, slowly pivot the rear section
forward until the curved locking brackets are fully con-
nected onto the top rear pegs. See figure 22.
4. Raise the tiller.
5. Secure the toggle latch. See figure 17.
n Lower the toggle latch buckle.
n Push back on the toggle latch so it locks into place.
6. Connect the front-to-rear harness and both battery
harnesses.
7. Replace the shroud.
8. Replace the seat, and lock it into place.
CAUTION! Position the front-to-rear
harness cable so it wont become
pinched between the frame halves
when pivoting the rear
section forward. See figure 22.
Figure 21. Frame Sections
Figure 22. Frame Lockup
FRONT-TO-REAR HARNESS CABLE