Filter
Top Products
19
Legend www.pridemobility.com
TILLER CONSOLE
The tiller console houses all of the controls needed to drive your scooter. See figure 5.
WARNING! Do not expose the tiller console to moisture. In the event that the tiller console
does become exposed to moisture, do not attempt to operate your scooter until the tiller
console has dried thoroughly.
V. YOUR LEGEND
Key Switch
n Insert the key into the key switch and turn it clockwise to power up (turn on) your scooter.
n Turn the key counterclockwise to power down (turn off) your scooter.
WARNING! If the key is turned to the off position while your scooter is in motion, the
electronic brakes engage and your scooter will come to an abrupt stop!
Figure 5. Tiller Console
BATTERY CONDITION METER
SPEED ADJUSTMENT DIAL
THROTTLE CONTROL LEVER
(REVERSE)
HORN BUTTON
THROTTLE CONTROL LEVER
(FORWARD)
KEY SWITCH
RUNNING LIGHTS SWITCH
STATUS LED
HEADLIGHT SWITCH
TURN SIGNAL BUTTON (RIGHT)
TURN SIGNAL BUTTON (LEFT)
HORN BUTTON
HAZARD LIGHT SWITCH
Throttle Control Levers
These levers allow you to control the forward speed and the reverse speed of your scooter up to the maximum
speed you preset with the speed adjustment dial.
n Place your right hand on the right handgrip and your left hand on the left handgrip.
n Use your right thumb to push the right side of the lever to disengage your scooters brakes and move forward.
n Release the lever and allow your scooter to come to a complete stop before pushing the other side of the lever
to move in reverse.
n When the throttle is completely released, it automatically returns to the center stop position and engages your
scooters brakes.
Speed Adjustment Dial
This dial allows you to preselect and limit your scooters top speed.
n The image of the tortoise represents the slowest speed setting.
n The image of the hare represents the fastest speed setting.
Status LED
The Status LED alerts you to electrical problems that may occur with the Legend. The LED remains constantly lit
while your scooter is on. If the Legend develops an electrical problem, the status LED will flash a code. See XI.
Basic Troubleshooting for diagnostic flash codes.