Filter
Top Products
22 www.pridemobility.com Jet 3/Rev I/Feb03
V. COMFORT ADJUSTMENTS
Figure 12. Wire Tie Location
Figure 11. Joystick Extension
Figure 10. Armrest Angle
To change the armrest height:
1. Loosen the armrest adjustment height setscrew located
underneath the armrest. See figure 9.
2. Raise or lower the armrest as desired.
3. Retighten the setscrew.
4. Repeat for the other armrest.
ARMREST ANGLE
You can adjust the armrest angle to fit your specific needs.
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicular to the
floor.
2. Use an 11 mm wrench to loosen the bolt. See figure 10.
3. Use a 11 mm wrench to loosen the bolt. Turn the screw
clockwise to raise the front of the armrest and counterclockwise
to lower the front of the armrest.
4. Lock the adjusting screw into place by tightening the jam nut.
JOYSTICK EXTENSION
The joystick control can easily slide out away from the armrest, or
in toward the armrest.
To extend the joystick:
1. Use a 5 mm hex key to loosen the setscrew. See figure 11.
2. Slide the joystick mounting bracket into or out of the armrest
to the desired position.
3. Retighten the setscrew by turning it clockwise.
JOYSTICK POSITION
You can position the joystick for either left-hand or right-hand use.
To change the joystick position:
1. Disconnect the controller harness connectors. See figure 5.
2. Cut the wire tie that attaches the controller cable to the armrest.
See figure 12.
3. Use a 5 mm hex key to loosen the setscrew. See figure 11.
4. Slide the joystick mounting out of the armrest.
5. Loosen the setscrew in the other armrest.
6. Place the joystick bracket in the other armrest.
7. Tighten the setscrew in each armrest.
8. Connect the controller cable to the armrest with a new wire
tie. See figure 12.
LOOSEN THIS
SETSCREW TO
ADJUST THE
JOYSTICK
USE A WIRE TIE TO
SUPPORT THE
CONTROLLER CABLE.
JAM NUT
BOLT