Filter
Top Products
34 www.pridemobility.com Select Traveller
VII. CARE AND MAINTENANCE
5. Slide the new wheel back onto the shaft. Make sure
that the key is in the axle slot.
6. Reinstall the drive wheel nut and washer onto the axle
and tighten.
7. Remove the power chair from the blocks.
Battery Replacement
A battery wiring diagram is printed on a decal located on
the front battery tray. See the Specifications Table for cor-
rect battery specifications.
WARNING! Battery posts,
terminals, and related
accessories contain lead
and lead compounds. Wear
goggles and gloves when
handling batteries and wash
hands after handling.
WARNING! The batteries in your power
chair should only be serviced or
replaced by an authorized Pride Provider
or a qualified technician.
WARNING! Do not replace batteries
when seat is occupied.
WARNING! Power chair batteries are
heavy. See specifications table. If you
are unable to lift that much weight, be
sure to get help.
Figure 17. Shroud Removal
WARNING! Use proper lifting techniques
and avoid lifting beyond your capacity.
Do not mix or match new and old
batteries. If you encounter a situation
where one battery needs to be replaced,
then replace both batteries. Refer to
specifications table in this manual and
the manual supplied with the battery
charger for recommended type and
capacities.
To replace the batteries:
1. Lift up on the shroud and slide the tabs out as shown in
figure 17.
2. Disconnect the battery strap.
3. Remove the red (+) positive and black (-) negative bat-
tery leads from each battery.
4. Remove the batteries.
5. Place the new batteries with the terminals facing out as
shown in figure 18.
Figure 16. Select Traveller Drive Wheel
DRIVE WHEEL NUT
DRIVE WHEEL WASHER
AXLE KEY
Figure 18. Battery Orientation
AXLE SLOT
- +
+ -