Filter
Top Products
20 www.pridemobility.com Select Traveller
III. YOUR POWER CHAIR
Electrical Components
The electrical components are located on the power base. The main circuit breaker is located toward the rear of the power
base. The controller and charger connectors are located on the rear of the power base. See figure 6.
Controller Connector: This is where the controller connects to the power base. Each controller uses a different type of
cable. Regardless of which type of controller is used, the cable must be secured to the seat assembly and not allowed to
drag on the floor.
Off-board Charger Connector: This is where the power module connects to the off-board charger XLR port which is
mounted underneath the joystick.
Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batteries and the
motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and
the electronics. If the circuit trips, allow your power chair to “rest” for approximately one minute. Next, push in the circuit
breaker button, turn on the controller, and continue normal operation. If the main circuit breaker continues to trip repeat-
edly, contact an authorized Pride Provider.
Figure 6. The Select Traveller Power Base
CIRCUIT
BREAKER
SEAT PEDESTAL
CONTROLLER CONNECTOR
FREEWHEEL
LEVERS
BATTERY COVER SHROUD
OFF-BOARD
CHARGER CONNECTOR