Filter
Top Products
Select Traveller www.pridemobility.com 23
IV. ASSEMBLY
Figure 9. Seat Installation
Seat Installation
It may be necessary to install the seat either prior to initial
operation or after transporting your power chair. The seat
is attached to the power base by a height-adjustable seat
pedestal.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so.
To install the seat:
1. Adjust the seat height if necessary. See V. “Comfort
Adjustments.”
2. Set the seat onto the seat pedestal. See figure 9.
3. Install the controller into the armrest, and tighten the
setscrew under the armrest.
4. Lift the armrest straight up, then route the controller
cable and secure with wire-ties as shown in figure 9.
WARNING! Prevent controller harness
damage! Use correct tie-down points for
controller harness.
5. Plug the controller cable into the connector on the power
base. See figure 6.