Filter
Top Products
24 www.pridemobility.com Jazzy 1103 Rev L/Feb03
VI. BATTERIES AND CHARGING
BATTERIES
The Jazzy uses two long-lasting, 12-volt, deep-cycle batteries. These batteries are sealed and maintenance free.
Since they are sealed, there is no need to check the electrolyte (fluid) level. Deep-cycle batteries are designed to
handle a longer and deeper discharge. Though they are similar in appearance to automotive batteries, they are not
interchangeable. Automotive batteries are not designed to handle a long, deep discharge, and also are unsafe for
use in power chairs.
CHARGING THE BATTERIES
The battery charger is essential in providing long life for your Jazzy batteries. See figure 3. The battery charger is
designed to optimize your Jazzys performance by charging the batteries safely, quickly, and easily. The charging
system consists of the charger, the charger fuse, and the ammeter. The onboard charger is located underneath the
electronics tray. The ammeter is located on the electronics tray for easy viewing. The charger has an in-line fuse
that protects the ammeter. The ammeter indicates the rate of charge necessary to fully recharge the batteries. It is
also a good indication of whether or not the charger is working. The ammeter and the charger are only functional
when the charger power cord is plugged into a wall outlet.
WARNING! Never use an extension cord to plug in your battery charger. Plug the charger directly
into a properly wired standard wall outlet.
WARNING! You must recharge your Jazzys batteries with the supplied onboard or the optional off-
board charging system. Do not use an automotive-type battery charger.
To charge the batteries using the onboard charger:
1. Position the rear of your Jazzy close to a standard wall outlet.
2. Be certain the controller power is turned off and the freewheel levers are in the engaged position. See IV. The
Jazzy 1103.
3. Remove the battery charger cord from the back pouch of your Jazzy and plug it into the onboard battery
charger AC power cord receptacle located on the electronics tray.
4. Extend the charger AC power cord and plug it into the wall outlet. The Jazzy incorporates an inhibit function
that disables the power chair when the charger is plugged into a wall outlet.
5. The ammeter indicates how much charge is needed to fully charge the batteries. Wait about a minute for the
charger to warm up. The ammeter may move as high as 5.5 amps, then gradually move back down to 0 amps
as the batteries charge.
6. We recommend you charge the batteries for 8 to 14 hours. As the batteries charge, the ammeter needle slowly
drops to 0. When the batteries are fully charged, the needle vibrates on or about the 0 mark on the ammeter
scale.
7. When your Jazzys batteries are fully charged, you can unplug the onboard battery charger AC power cord
from the wall outlet, wind it up using the hook and loop strap, and place the cord back into the Jazzys back
pouch.
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.
Wash hands after handling.