Filter
Top Products
32
www.pridemobility.com Celebrity X LE
SEAT SLIDING LEVER
VI. COMFORT ADJUSTMENTS
To adjust your scooter’s reclining seat, perform
these steps. See figure 16.
1. With your back pressed up against the seatback,
lift up on the seatback adjustment lever and
lean forward or backward to adjust the seatback
angle.
2. Release the seatback adjustment lever once the
seat is in a comfortable riding position.
SEAT ROTATION ADJUSTMENT
The seat rotation lever will secure the seat into
several positions.
1. Push forward on the seat rotation lever to
disengage the seat. See figure 16A.
2. Rotate the seat to the desired position.
3. Release the lever to secure the seat into place.
FRONT-TO-BACK SEAT ADJUSTMENT
You can reposition the seat forward or backward to
adjust the distance between the seat and the tiller.
See figure 16A.
1. Move the seat sliding lever outward.
2. While holding the lever out, slide the seat for-
ward or backward.
3. Release the seat sliding lever once the seat is in
the desired position.
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights.
See figure 17.
1. Remove the seat and shroud from your scooter.
See VII. “Disassembly and Assembly.”
2. Loosen the seat height adjustment nut and
remove it from the bolt. Remove the bolt and
washers.
3. Loosen the clamp-action bolt.
4. Raise or lower the upper seat post to the desired
seat height.
5. While holding the upper seat post at that height,
Figure 17. Seat Height Adjustment
LOWER SEAT POST
SEAT HEIGHT
ADJUSTMENT
BOLT
SEAT HEIGHT
ADJUSTMENT
NUT
CLAMP-ACTION
BOLT
CLAMP-ACTION
NUT
LOCATING
HOLE
UPPER SEAT
POST
SEAT ROTATION LEVER
Figure 16A. Seat Adjustment Levers
match up the locating holes in the upper seat post with those of the lower seat post.
6. With one washer on the seat height adjustment bolt, insert it through the locating holes of both the
upper and lower seat posts.
7. Reinstall the other washer and nut and tighten.
NOTE: Ensure both washers have been reinstalled before fully tightening the seat height adjustment nut.
8. Tighten the clamp-action bolt.
9. Reinstall the rear shroud and the seat.
BOLTS