Filter
Top Products
30 Maxima
VIII. COMFORT ADJUSTMENTS
ARMREST HEIGHT ADJUSTMENT
You will need the following tools to adjust the height
of the armrests:
5/32 Hex Key 1/8 Hex Key 7/16 Wrench
1. Loosen the setscrew on the side of the height
adjustment tube with the 1/8 hex key.
2. Loosen and remove the acorn nut and screw hold-
ing the height adjustment tube in place.
3. Raise or lower the height adjustment tube to the
desired height.
4. Align the holes in the adjustment tube with the
holes in the armrest upright.
5. Insert the screw through the holes in both the height
adjustment tube and the armrest upright.
6. Install and tighten the acorn nut.
7. Tighten the setscrew on the side of the height
adjustment tube.
8. Repeat for the other armrest.
ARMREST WIDTH ADJUSTMENT
The armrest width of your Maxima can be adjusted inward or outward.
1. Loosen the armrest adjustment knobs at the back of the seat frame. See figure 16.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs. The armrests can also be lifted upward to allow getting on and off of
your Maxima easier.
90° ADJUSTMENT HOLE
100° ADJUSTMENT HOLE
102° ADJUSTMENT HOLE
105° ADJUSTMENT HOLE
FIGURE 16A. SEATBACK HINGE
ADJUSTMENT SCREW
UPPER HINGE
LOWER HINGE
SEATBACK ADJUSTMENT
The seatback can be positioned to four different angles:
90°, 100°, 102° and 105°. See figure 16A.
To adjust the seatback angle:
1. Loosen and remove the adjustment screw from the
seatback hinge on both sides of the seat.
2. Reposition the seatback to the desired angle.
3. Align the adjustment holes in the upper and lower
hinge, so the adjustment screw can easily pass through.
4. Reinsert both adjustment screws and tighten.
FIGURE 16. ARMREST ADJUSTMENTS
ARMREST UPRIGHT
SETSCREW
HEIGHT ADJUSTMENT
TUBE
ARMREST ADJUSTMENT
KNOB
ACORN NUT