Filter
Top Products
18 www.pridemobility.com Select Traveller
III. YOUR POWER CHAIR
Electrical Components
The electrical components are located on the power base. The main circuit breaker is located toward the rear of
the power base. The controller connector is located on the rear of the power base. See figure 6.
Controller Connector: This is where the controller connects to the power base. Each controller uses a different
type of harness. Regardless of which type of controller is used, the harness must be secured to the seat assembly
and not allowed to drag on the floor.
Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batteries
and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage
to the motors and the electronics. If the circuit trips, allow your power chair to “rest” for approximately one
minute. Next, push in the circuit breaker button, turn on the controller, and continue normal operation. If the main
circuit breaker continues to trip repeatedly, contact an authorized Pride Provider.
Figure 6. The Select Traveller Power Base
MAIN CIRCUIT
BREAKER
SEAT PEDESTAL
CONTROLLER CONNECTOR
MANUAL FREEWHEEL
LEVERS
BATTERY COVER