Filter
Top Products
26 www.pridemobility.com Quantum 600 Series
Figure 16. Seat Position Adjustment
V. COMFORT ADJUSTMENTS
10. Reinstall the retaining clips.
11. Remove each screw from the trapeze bars and apply
thread lock.
12. Reinstall each screw into the trapeze bars and tighten.
13. Reinstall the seat.
14. Reconnect the controller to the power base.
15. Reinstall the rear shroud by aligning the side and back
tabs with the holes in the main shroud. Gently push
down and forward until all four tabs lock into place.
Seat Position Adjustment
You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the power base.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mounting
holes. You must move both extrusions the same number
of holes either forward or backwards. See figure 16.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Reconnect the controller.
Manual Recline Seatback Adjustment
If your power chair seat is equipped with a reclining seat-
back, you can adjust the seatback angle with the seatback
release lever. The lever is located on the right side of the
seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the lever.