Filter
Top Products
26 www.pridemobility.com Jazzy 614 Series
FOOT PLATFORM BRACKET
SECUREMENT NUT
V. COMFORT ADJUSTMENTS
Controller Position
You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in the
seat frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the
floor.
2. Loosen the setscrew on the controller bracket. See
figure 17.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the power
base.
3. Cut the wire tie(s) securing the controller harness
to the armrest.
4. Flip up the armrest and loosen the setscrew. See
figure 17.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrews in each armrest.
9. Secure the controller harness to the armrest with
wire ties.
10. Plug the controller connector(s) into the power
base.
NOTE: If your power chair is equipped with a TRU-
Balance Seating System, refer to the controller adjust-
ment information contained in separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several
different heights.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform
bracket. See figure 18.
2. Loosen the foot platform securement nut one-half
turn.
3. Raise or lower the foot platform to the desired
height.
4. Reinstall the hardware into the foot platform
bracket and tighten.
5. Tighten the securement nut.
Figure 17. Underside of Armrest
Figure 18. Foot Platform Adjustment
SETSCREW
CONTROLLER
BRACKET