Filter
Top Products
24 www.pridemobility.com Jazzy 614 Series
V. COMFORT ADJUSTMENTS
10. Reinstall the retaining clips from step 8.
11. Remove each screw from the trapeze bars and
apply thread lock.
12. Reinstall each screw into the trapeze bars and
tighten.
13. Tighten the setscrew in each seat tower. See figure 14.
14. Reinstall the seat.
15. Lift the armrest straight up, then route the control-
ler harness so that it can not be pinched in the seat
hinge. See figure 11.
16. Reconnect the controller to the power base.
17. Secure the controller harness with one or more wire
ties. See figure 12.
Seat Position Adjustment
You can move the seat forward or rearward by chang-
ing the extrusion mounting position.
To change the seat position:
1. Unplug the controller connector(s) from the power
base.
2. Remove the seat from the power base.
3. Remove both extrusions from the bottom of the
seat.
4. Reposition the extrusions on a different set of
mounting holes. You must move both extrusions
the same number of holes either forward or back-
wards. See figure 15.
5. Fasten the extrusions back onto the bottom of the
seat.
6. Reinstall the seat.
7. Lift the armrest straight up, then route the control-
ler harness so that it can not be pinched in the seat
hinge. See figure 11.
8. Reconnect the controller.
9. Secure the controller harness with one or more wire
ties. See figure 12.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat,
you can adjust the seatback angle with the seatback
release lever. The lever is located on the right side of
the seat base. See figure 5.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backwards to the desired position.
3. Release the lever.
Figure 15. Seat Position Adjustment