Filter
Top Products
30 www.pridemobility.com Jazzy 1103 Ultra
Positioning Belt
Your power chair may be equipped with a positioning belt
that can be adjusted for operator comfort. See figure 23.
The positioning belt is designed to support the operator so
that he/she does not slide down or forward in the seat. The
positioning belt is not designed for use as a restraining
device.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to
the seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through
the positioning belt and into the seat base for each side
of the power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt
into the plastic housing on the opposite side until you
hear a click. See figure 23.
2. Pull the excess strap attached to the metal tab until it is
secure, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning
belt is properly secured to the power
chair and is adjusted for operator
comfort before each use.
MANDATORY! Inspect the positioning
belt for loose or damaged parts before
each use of the power chair. If you
discover a problem, contact your
authorised Pride Dealer for maintenance
and repair.
V. COMFORT ADJUSTMENTS
Figure 23. Positioning Belt