Pride Mobility 1103 Wheelchair User Manual


 
Jazzy 1103 Ultra www.pridemobility.com 29
WARNING! Failure to heed the following
warnings may cause the power chair to tip
over.
WARNING! Always fasten the positioning
belt when operating the power elevating
seat system.
WARNING! Never raise the seat from its
lowest position on an inclined surface.
WARNING! Never raise the seat from its
lowest position when operating your power
chair on bumpy or uneven surfaces.
WARNING! Never raise the seat while your
power chair is in the freewheel mode.
WARNING! Maintain recommended tyre
pressure in the drive wheel to maintain
stability.
Power Elevating Seat Operation
If your power chair is equipped with a power elevating seat, you can change the seat height either through the controller or
through a toggle switch mounted to one of the armrests.
To operate the power elevating seat:
1. Bring your power chair to a complete stop.
2. Push the toggle switch forward to raise the seat or pull the switch rearward to lower the seat. When you release the
switch, the seat will stop.
NOTE: The power elevating seat system has an upper and a lower limit of travel. Once the actuator reaches
either one of these limits, you should continue to hear and/or feel the actuator motor running. This is because
there is a clutch mechanism that allows the motor to continue running after the actuator has reached its limit.
This clutch works at both the top and bottom extensions of the lift.
WARNING! Do not allow the motor to run more than a few seconds after the mechanism reaches
the top or bottom limit. This can damage the motor.
The power elevating seat is equipped with a swivel feature that allows the seat to be turned 90 degrees to whichever side
the controller is located.
To use the swivel feature:
1. Locate the friction lock lever under the seat. See figure 12.
2. Pull back the friction lock lever to rotate the seat in 90° increments.
3. Pull the friction lock lever forward to lock the seat in place.
WARNING! Do not attempt to drive the power chair with the seat facing to the side. Always return
the seat to the forward facing position before operating the power chair.
V. COMFORT ADJUSTMENTS
Figure 22. Power Elevating Seat Actuator