Filter
Top Products
6
Blender
Air-Oxygen
SPECIFICATIONS continued
Dimensions: (without fittings)
Depth: 4.9 in
(12.5 cm)
Width: 2.3 in
(5.7 cm)
Height: 4.1 in
(10.4 cm)
Weight: 2.9 lbs
(1.3 kg)
Shipping Weight: 3.5 lbs
(1.6 kg)
Operating Temperature Range:
59°F to 104°F (15°C to 40°C)
Transport / Storage Requirements
Temperature Range:
-10°F to 140°F (-23°C to 60°C)
Humidity:
Max 95% Noncondensing
FiO2 Accuracy:*
± 3% of full scale @ 50 psi (3.4 bar)
± 4% of full scale @ 60 psi (4.14 bar)
Pressure Drop:
Low Flow:
≤ 2 psi (0.14 bar) at inlet pressures from 30-90 psi
(2.1- 6.2 bar) and at 10 lpm flow rate at 60% FiO
2
.
High Flow:
≤ 3 psi (0.21 bar) at inlet pressures from 30-90 psi
(2.1- 6.2 bar) and at 30 lpm flow rate at 60% FiO
2
.
The Air-Oxygen Blender has been degreased for Oxygen Service prior to delivery.
The Air-Oxygen Blender reverse gas flow complies with clause 6 of ISO 11195.
The Oxygen Analyzer should comply with ISO 7767 to meet CE requirement.
Dryness and Composition for inlet gases:
Air:
Medical Air supply should meet the requirements of
ANSI Z86.1 - 1973 commodity specification for Air, type
1 grade D or better.
Oxygen:
Oxygen supply must meet all requirements of USP
Medical Oxygen Grade N.
Dew Point:
(ONLY for CE
requirements)
Both inlets should remain 10°F (5.5°C) or more
below the lowest temperature to which the air
distribution system equipment is exposed. At a
temperature of 25°F (-3.9°C) and a pressure of
90 psi (6.33 kg/cm
2
) this equates to 2000 mg/m
3
.
* Accuracy of oxygen concentration will be affected if bleed is not activated at flow settings below 15 lpm for the high flow
Blender, and 3 lpm for the low flow Blender.
Specifications are subject to change without prior notice.