Filter
Top Products
2 Separate the two housing parts by means of a screwdriver
(fig. 15).
3 Pull out the printed circuit board (fig. 16).
4 Remove the rechargeable battery by means of a screwdriver and
detach it by bending or turning it several times until the
connections break (fig. 17).
5 Dispose of the battery and the other components in an
environmentally safe way.
Do not connect the appliance to the mains again after it has been
opened.
Guarantee & service
If you need information or if you have a problem, please visit the Philips
website at www.philips.com or contact the Philips Customer Care
Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and Personal Care BV.
Troubleshooting
The trimmer does not work when it is switched on and none of the
lights go on:
1 If the battery is completely empty, the trimmer will not work and
the lights will not go on when the appliance is switched on.
Charge the appliance until it is fully charged (also see chapter
'Charging'). Charging will take approx. 10 hours.
If the suction system of the vacuum beard trimmer performs poorly or
does not work at all, check the points listed below.
2 Is the hair-collection chamber empty? (fig. 10).
B
We advise you to empty the hair-collection chamber after each
trimming session.When cutting long, dense beards it may also be
necessary
ENGLISH12