Filter
Top Products
C ◗ Cleaning Indicator
The blinking faucet symbol and the short beep
will remind you that razor heads need to be
cleaned.This happens approximately once a week
(in the case of normal use).
C ◗ Replacement Head Indicator
Every year, depending on your shaving behavior,
after turning the razor OFF, a few beeps are
audible for 3 seconds and the replacement head
symbol indicator as well as the word REPLACE
will be visible. It will remain visible for 2 weeks to
remind you that with new shaving heads you will
guarantee yourself optimal shaving performance.
After 1 week the beeps are audible for 5 seconds.
After 2 weeks the beeps are audible for 10
seconds.
Charge Meter
◗ Charge Meter monitors amount of remaining
battery power and actual remaining shaving
minutes available. “Minutes Left” is based on
the amount of power consumed shaving per
minute and is dependent upon your skin and
beard type, whether you use pre-shave lotion,
and how often the trimmer is used.
◗ Initially your razor may need to go through 2
or 3 full charge/recharge cycles before
“Minutes Left” indicator begins to display your
accurate “Shaving Minutes Left.”
ENGLISH 13ENGLISH12
◗ Low Battery Indicator
C - The Numeric Display:
When the battery is running low, the plug symbol
and the “0” will blink after you have turned the
razor OFF. You will also hear a few short beeps.
If this occurs while shaving, you should have
enough power to complete your shave.
When you turn razor ON or OFF the display will
come on for approximately 10 seconds.
C - The Blocks Display:
When the battery is running low, the plug symbol
and red block will blink after you turn razor OFF
and you will also hear a few short beeps.
When you turn razor OFF or ON the display will
stay on for approximately 10 seconds.
C ◗ Demonstration Program
The razor has a 1-minute demonstration program
that will run through the full display of razor
functions. During the demonstration the razor will
automatically turn ON and OFF 4 times. To
activate, press and hold the ON/OFF button for
6-10 seconds until all symbols disappear on the
display. Then release the button and the razor will
continue through the 1-minute demonstration
program.You can interrupt the demonstration by
pressing the ON/OFF button again.
8894_95XLDFUwspanish.qxd 5/28/04 10:21 AM Page 12