Filter
Top Products
ENGLISH 19ENGLISH18
Preparing Jet Clean System For Use
Important
◗ Only use the razor,power plug,Jet Clean System
and HQ200 cleaning solutionprovidedto charge
or clean razor.
◗ Only use a Philips Norelco ‘XLCC’ model
razor with the Jet Clean System.
◗ Other Philips Norelco‘X’,‘XL’ or‘LC’ model
razors DO
NO
T work witha Jet Clean System.
◗ Empty the cleaning solution canister and
thoroughly rinse the canister clean with warm
water every 2 weeks.
◗ The Jet Clean System thoroughly cleans but
does not disinfect your razor, therefore, do not
share razor with others.
◗ Thecharging plugconverts 100-240VACto
less than 24VDC.
◗ Place the Jet Clean System ona flat, stable
surface to avoid any leakage. Be careful not to tip
or movethe Jet Clean System ifit is filledwith
the cleaning solution.
◗ To avoid evaporation,do not expose cleaning
solution to direct sunlight.
◗ Remove the protective razor head cap from
the razor before charging or cleaning the razor
in the Jet Clean System.
◗ Use this appliance for its intended household
use as described in this manual.
1 Place the Jet Clean System ona flat,level
surface.
C 2 Lift the transparent cleaning reservoir
from the Jet Clean System.
C 3 Turn thereservoir cap counterclockwise
(1) and removefrom the cleaning
reservoir (2).
4 Unscrew the lidon the Jet Clean Solution
bottle (Model HQ200)providedwith the
razor. Removethe airtight seal by liftingup
the tabs onthe seal. Replace lidon the bottle
making sure the lidis screwed onsecurely.
5 Open lid andpour the Jet Clean Solutioninto
the transparent cleaning reservoir. The
reservoir canbe completely filledwith one
(1) bottle ofthe JetClean Solution (Model
HQ200).Discard cleaning solution bottle
after contents have beenpoured into the
reservoir.
NO
TE:
ONL
Y USE PHILIPS NORELCO JET
CLEAN
SOLUTION (MODEL
HQ200)WITH
THE
JET CLEAN
SYSTEM. ANY OTHER
SOLUTION
MAY
CAUSE DAMAGE TO YOUR
RAZOR.