Filter
Top Products
14
15
ENGLISH
head assembly symbol and faucet symbol with
exclamation mark remain on the display,
immediately replace the Razor Head Assembly
(see ‘Replacing Razor Head Assembly’).
Charge Meter
◗ Charge Meter monitors amount of remaining
battery power (Models 1060X and 1059X)
and actual shaving minutes (Model 1090X)
available. ‘Minutes Left’ or remaining
battery capacity is based on the amount of
power consumed shaving per minute and is
dependent upon your skin and beard type,
whether you use pre-shave lotion, and how
often the trimmer is used.
◗ Initially your razor may need to go through
2 or 3 full charge/recharge cycles before
‘Minutes Left’ (Model 1090X) or remaining
battery capacity indicators (Models 1060X
and 1059X) begins to display your accurate
shaving minutes left.
Before First Use
◗ Charge the razor before you start using
it (see ‘Charging’). Make sure the razor is
switched off before you start charging it.
◗ Remove any sticker or protective foil from
the Display before using razor.
ENGLISH
Important
◗ Only use the power cord and charging stand
or power pod provided to charge
the razor.
◗ The power plug transforms 100-240V AC to
less than 24V DC.
◗ Do not attempt to disassemble the Razor
Head Assembly to individually clean each
cutter and comb. The individual shaving heads
are not removable.
Travel Lock
The razor is equipped with a travel lock function.
You can use the travel lock function when you are
going to store the razor for a longer period or if
you are going to take the razor with you when
traveling. See ‘Travel Lock’ section for instructions
on how to use this function.
Charging
◗ Charging or recharging at temperatures below
40ºF or higher than 95ºF adversely affects
lifetime of batteries.
◗ Always unplug this charging stand/pod from
the electrical outlet immediately after use,
except when razor is (re)charging. You can
store the razor in the charging stand or
power pod.
◗ Charging or recharging requires one full hour.