Filter
Top Products
13
English
14
English
Inserting the Batteries into the Wireless Display
*Always use alkaline batteries. (2 AA-size LR6 alkaline batteries)
When replacing batteries, always use 2 fresh alkaline batteries of the
same type from the same manufacturer, and replace them
simultaneously.
1. Turn the wireless display over and remove
the battery cover by sliding it in the
direction of the arrow while pressing
lightly on the mark.
2. Check the polarities of the batteries and
install them correctly.
3. Replace the battery cover and slide it
closed.
Replace
batteries when:
The mark shown at left appears during use.
In this case, press the On/Off and the Start button on the
main unit to interrupt the measurement.
•
If both batteries for the main unit and the wireless display must be
replaced at the same time,
(main unit) and (wireless display)
are alternately displayed.
•
Setting the time and date
* Please be sure to set the date and time before taking the first
measurement after purchasing the blood pressure monitor, or after
replacing the batteries.
(If you attempt to take measurements without first setting the time and
date then “–” will be displayed.)
1. Press the Set button “1” on the wireless
display for at least 3 seconds.
2. Adjust the month.
Press the Adjust button “2” to adjust the
number of the month.
3.
Adjust the date.
(1) Press the Set button “1” and the number for
the date will flash.
(
2) Press the Adjust button “2” to adjust the
number of the date.
4. Adjust the hour.
(1) Press the Set button “1” and the time will
flash on and off.
(
2) Press the Adjust button “2” to adjust the
number of the hour.
5. Adjust the minutes.
(1) Press the Set button “1” and the number for
minutes will flash.
(
2) Press the Adjust button “2” to adjust the
number of minutes.
6. Finally, synchronizing with a time signal,
press the Set button “1” to complete the
procedure.
The date and time are alternately displayed in
appro
ximately 2 seconds.
7.
Press the Adjust button “2” to turn off the unit.
•
During leap years, 3/1 will be displayed when it is February 29th. Please
manually reset the date to 2/29.
13-14 2008/01/15 14:54:25