9
English
Cleaning with the self-cleaning recharger (continued)
Follow the steps outlined below if the status lamp blinks or glows
during the “Clean/Dry/Charge” course.
Blinks Glows
Correctly set the
detergent cartridge and
then restart a course.
Remo
ve the shaver from the self‑
cleaning recharger and then
check that the [CLEAN] lamp has
gone out. (Be careful as the blade
may be hot or wet.) Check that
the water tank is correctly
attached, the water tank cap is
securely closed and the self‑
cleaning recharger is placed
horizontally.
If the status lamp goes
out
Continue a course.
When an abnormality has
been corrected
When no abnormality was
found
Press and hold [SELECT] for
appro
ximately 2 seconds to
turn off the status lamp and
then restart a course.
It is time to replace the
detergent cartridge and
cleaning liquid inside the water
tank.
Drain the old cleaning liquid
inside the water tank and then
refill it with water. Replace the
old detergent cartridge and
then restart the course.
When the status lamp
goes out
When the status lamp glows
again
Continue a course. Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
We recommend that you clean
your shaver with the self‑cleaning
recharger or the “sonic” vibration
turbo‑cleaning mode when the
faucet symbol appears on the
LCD panel.
1. Disconnect the power cord
from the shaver.
2. Apply some hand soap and
some water to the outer foil.
3. Slide the switch lock button
downwards to unlock the OFF/
ON switch.
4. Press the OFF/ON switch for
more than 2 seconds to
activate the turbo mode for
“sonic” vibration cleaning.
appears on the LCD
panel.
After about 20 seconds, it
will be automatically turned
off, or you can turn it off by
pressing the OFF/ON switch.
5. Remove the outer foil section
and press the OFF/ON switch
for more than 2 seconds to
activate the turbo mode for
“sonic” vibration cleaning and
clean it with running water.
6. Wipe off any drops of water
with a dry cloth.
•
•
7
ES-LA93_USA.indb 9 2009/06/08 11:12:42