Filter
Top Products
8
English
Cleaning the shaver
1
1
Insert the appliance plug.
2
2
Plug in the adaptor.
Remove any soap or water on the shaver if
it has been washed with hand soap or any
other detergent.
•
2
1
3
3
Remove the protective cap
and then attach the shaver.
Turn the shaver off before attaching.
Check that the outer foil is not deformed or
damaged when you are attaching the
shaver.
•
•
3
4
4
Press [SELECT] to select the
course.
The “Charge” course starts when attaching
the shaver.
Each time you press [SELECT], the course
changes from “Clean/Dry/Charge” “Dry/
Charge” “Charge”.
•
•
The courses start approximately 6 seconds after they are
selected.
The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
Do not detach the detergent cartridge or the water tank as the
cleaning liquid may spill causing a malfunction.
•
•
•
Course
Course
selection
indications
Time required (guide)
[In the low
temperature]
Charge
Charge (0 to 60 min)
Clean/Dry/
Charge
Clean (10 min)
Dry (80 min [170 min])
Charge (0 to 60 min)
Dry/Charge
Dry (180 min)
Charge (0 to 60 min)
ES-LA93_USA.indb 8 2009/06/08 11:12:41