Filter
Top Products
10
English
Replacing the system outer foil and the inner
blades
system outer foil once every year
inner blade once every two years
Replacing the system outer foil
1. Press the system outer foil
release buttons and lift the
system outer foil upwards as
illustrated.
2. Insert the system outer foil by
pushing it downwards until it
clicks.
Replacing the inner blades
1. Press the foil frame release
buttons and lift the foil frame
upwards as illustrated.
2. Remove the inner blades one
at a time as illustrated.
Do not touch the edges
(metal parts) of the inner
blades to prevent injury to
your hand.
3. Insert the inner blades one at
a time until they click as
illustrated.
•
2 3
1
1
Cleaning the self-cleaning recharger
Beard trimmings may become attached to the cleaning tray of the
self-cleaning recharger. Follow the steps below to remove them.
We recommend doing this each time you change the detergent
cartridge.
1
1. Be sure to remove the water
tank and the appliance plug
from the self-cleaning
recharger.
Be careful not to spill the
cleaning liquid.
2. Gently wipe off any beard
trimmings attached to the
inside of the cleaning tray
with a cloth or tissue paper
dampened with water.
Clean the corners and
uneven parts of the cleaning
tray with a cotton swab
dampened with water.
•
•
2
Do not pull hard on the rubber blade protector at the bottom of
the cleaning tray. The rubber may come off if you pull hard on it.
It is only necessary to pull it up slightly.
Warning - Do not wash or apply water to the adaptor or self-
cleaning recharger. Failure to observe this may cause electric
shock or result in short circuits.
•
•
ES7109_USA.indb 10 2007/07/12 12:56:28