Filter
Top Products
7
English
8
English
Changing the Massage Mode
Press .
The massage mode used can be switched via the controller.
• Press once to
switch to
Knead A.
• Press a second
time to switch
to Knead B.
• Press a third
time to switch
to Combined.
• Press a fourth
time to switch
back to Knead A.
The mode can also be changed midway through a massage.
When the mode is changed, the new selected massage will start after all
the air has been released.
•
•
Knead A
A slow and thorough massage is given using an upward squeezing action on the selected part
of the body.
Recommended for people who are prone to swelling.
•
•
Knead B
Muscles are pleasantly loosened with rhythmical pressure.
Recommend for tired leg muscles from exercising, etc.
•
•
Combined
Fatigue is pleasantly relieved and blood circulation in the legs is promoted by a variety of
massage actions of varying rhythms, in addition to that of modes Knead A and B above.
•
Massage Mode DescriptionsMassage Mode Descriptions
Adjusting the Intensity
Press .
The intensity of the massage can be adjusted in three steps.
One lamp lights up with each step adjusted.
Intensity 3
Intensity 2
Intensity 1
Stronger
Weaker
•
•
AFTER COMPLETING THE MASSAGE
Disconnect the Power Plug.
When not in use for extended periods of time, please disconnect the power plug from the outlet as a
measure to save energy.
(Noise may be heard when operationally idle, as approx. 5 W of electricity are used even when not in operation.)
CAUTION
Unplug the power plug from the outlet when the unit is not in use.
Failure to observe this precaution may result in electrical fire due to deterioration of insulation caused by dust
and moisture.
Always hold the power plug, not the power cord, when unplugging from an outlet.
Failure to observe this precaution may result in electric shock or short-circuit.
•
•
Return the Massage Section to Its Original Position.
Pull the angle lock lever outward and return the massage section.
(See Page 5)
•
Return the Controller to the Holder.
Both the controller and the controller cord can be stored
in the holder on the underside of the unit.
• Return the controller to the controller holder. •
•
7-8 2007/12/19 18:05:57