Filter
Top Products
9
English
10
English
CLEANING AND MAINTENANCE
CAUTION
When performing cleaning and maintenance, always disconnect the power cord from the outlet. Never
touch the power plug with wet hands.
- Failure to observe these precautions may result in electric shock or burns.
•
Frame Section and Plastic Parts
(1) Wipe these areas with a cloth that has been soaked in a mild detergent and then
thoroughly wrung out.
(2) Next wipe with a cloth that has been moistened with just water and thoroughly
wrung out.
* Make sure you thoroughly wring out the cloth first when cleaning the controller.
(3) Allow the unit to dry naturally.
Please do NOT use thinners, benzine or alcohol.•
Areas Covered with Fabric
(1) Wipe these areas with a cloth that has been soaked in a mild detergent and then
thoroughly wrung out.
(2) Use a mild detergent and brush on areas where the fabric has become particularly
soiled. Be careful not to brush the fabric too much as you may damage it.
(3) Next wipe the fabric with a cloth that has been moistened with just water and
thoroughly wrung out.
(4) Allow the fabric to dry naturally.
Please do NOT use thinners, benzine or alcohol.•
Areas Covered with Synthetic Leather
Wipe these areas with a soft, dry cloth. (Do NOT use cloths containing any kind
of chemical, etc.)
If the synthetic leather becomes particularly dirty, promptly soak a soft cloth in
water or a 3-5% solution of mild detergent, wring it out thoroughly and tap the
surface with it. Next, rinse the cloth in water, wring it out thoroughly and then
wipe any remaining detergent from the surface, wipe the surfaces with a soft
dry cloth and allow them to dry naturally.
(Do NOT use a hair dryer to try to dry the surfaces more quickly.)
Wipe off stubborn stains with a commercially available melamine foam sponge
soaked in a neutral detergent.
Wearing of denim, colored, patterned or other clothing with a tendency to fade should
be avoided during use, as it could lead to discoloration of the synthetic leather.
Do not allow these areas to come in contact with plastic for extended periods
of time as this may lead to discoloration.
Please do NOT use thinners, benzine or alcohol.
•
•
•
•
•
•
STORING THE UNIT
When moving the unit, carry it using both hands.
Hand grips are provided on the upper part of the unit.
Do NOT store in the following places.
- Places accessible to children
- Places with exposure to water
- Places with exposure to high heat, humidity, direct sunlight, or air containing
dust and salt, etc.
- Places with exposure to vibration, shock or tilting
- Places where chemicals are stored or corrosive gases are produced
•
•
Hand Grip
TROUBLESHOOTING
Noises during operation
The following sounds during operation are caused by the construction of the unit and are normal.
Sound of inflating air
Sound of deflating air
Sound of a pump working
Clattering sound from massage section
Clacking sound from the massage section when adjusting the angle
Symptom Cause and Remedy
Emits “beep” sound and then
stops.
The
unit has automatically stopped because 15 minutes have passed since the
massage started. Please take a 10-minute break after completing a 15-minute
massage.
Does not operate. Is the power plug connected?
Firmly insert the power plug. (See page 5)
Is there a break in the power cord?
Foot Massager is damaged. Immediately stop use.
If there is still a problem after checking the Foot Massager, immediately stop use. To prevent accidents in this case,
be sure to ask your dealer to inspect/repair the unit.
SPECIFICATIONS
Product Name: Foot Massager
Power Supply: AC 120 V 60 Hz
Power Consumption: 25 W
Automatic Shut-Off: Approx. 15 min.
Dimensions (H × W × D): Approx. 17
3
⁄8 in. × 25
1
⁄4 in. × 12
1
⁄4 in. (440 mm × 640 mm × 310 mm)
Weight of Unit: Approx. 33
1
⁄8 lb (15 kg)
•
•
•
•
•
9-10 2007/12/19 18:05:58