9
GB
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
FCC :
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
o Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and receiver.
o Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
o Consult the dealer of an experienced radio/TV technician for help.
Company Name: Oregon Scientific, Inc.
Address: 19861 SW 95th Place, Tualatin, Oregon 97062, USA
Telephone Number: (1)503-6398883
Name and model number of the product: Digital Weather Forecaster
with Remote Thermo-Hygro sensor and Radio Controlled Clock
BAR112HGA
RF Transmission Range : Maximum 100 feet
(30 meters)
Temperature sensing cycle : around 30 seconds
Power
Main unit : use 2 pcs UM-3 or “AA”
1.5V alkaline battery
Remote sensing unit : use 2 pcs UM-4 or
“AAA” 1.5V alkaline
battery
Weight
Main unit : 8.82 ounces (250 g)
(without batteries)
Remote sensing unit : 3.51ounces(100g)
(without batteries)
Dimension
Main unit : 4.61x4.21x1.07inches
(117 x 107 x 26 mm)
Remote sensing unit : 3.62x2.36x.83 inches
(92 x 60 x 21 mm)
NOTE ON COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesired operations.