Filter
Top Products
6
GB
THE RESET BUTTON
This button is only used when the unit is operating in an
unfavorable way or malfunctioning. Use a blunt stylus to hold
down the button. All settings will return to their default values.
GETTING STARTED
Once batteries are in place for the remote units, they will start
transmitting temperature readings at 30-second intervals.
The main unit will also start searching for signals for about a
minute once batteries are installed. Upon successful reception, the
individual channel temperatures will be displayed on the 2nd line
and the indoors temperature on the 3rd line. The main unit will
automatically update its readings at about 30-second intervals.
If no signals are received, blanks “
” will be displayed and
the kinetic wave icon will show “ ”. Press CHANNEL and
MEMORY simultaneously to enforce another search for about 30
seconds. This is useful in synchronizing the transmission and
reception of the remote and main units.
Repeat this step whenever you find discrepancies between the reading
shown on the main unit and that on the respective remote unit.
HOW TO CHECK REMOTE AND
INDOORS TEMPERATURES
The indoors temperature is shown on the 3rd line of the display.
As for the remote sites or channels, press CHANNEL to go from one
channel to another. The kinetic wave display on the channel number
indicates the reception of that particular channel is in good order.
If no readings are received from one particular channel for more
than two minutes, blanks “
” will be displayed until further
readings are successfully searched. Check the remote unit is sound
and secure. You can wait for a little while or press CHANNEL and
MEMORY simultaneously to enforce an immediate search. Of course
no reading will be shown if no remote unit is assigned to that
channel.
The temperature trend indicator on the screen shows the trend of
samplings collected at that particular remote site. Three trends,
rising, steady and falling, will be shown.
If the temperature goes above or below the temperature measuring
range of the main unit or the remote unit (stated in specification) ,
the display will show “HHH” or “LLL”.
Arrow
indicator
Temperature
Trend
Steady FallingRising