Filter
Top Products
9
Measurement
Completed
Alternate Display
Blood Pressure
Reading Display
(for approx 3
seconds)
Pulse Reading
Display
(for approx 15
seconds)
*P: Stands for PULSE
Preparations for Use
8 Blood Pressure and Pulse are displayed
When the deation symbol begins to ash,
the residual pressure in the cuff is then
rapidly released
1 When the unit has continued to deate
to a point when the artery oscillations are
no longer detected, the unit will display
the systolic and diastolic blood pressure
values, along with a long beep, and causes
the deation indication symbol ( ) to start
ashing After this, blood pressure and the
pulse readings are displayed alter-nately
* When you wish to stop measuring during
operation, press the SPHYGICLOCK
button The pump will stop and all the cuff
pressure will be released rapidly
* When the PRINT button is pressed while
the results of the measurement are shown
on the digital display, the results will be
printed
3 Measurement of the blood pressure is
now complete The results will remain
displayed even after the cuff is taken
off If you wish to carry out repeated
measurements, repeat the operation from
Step 6
* The arm gradually becomes congested
when measurements are repeatedly
taken If you wish to take consecutive
measurements, take off the cuff and
wait at least 3 to 5 minutes between
measurements
4 When measurement is completed press
the SPHYG/CLOCK button to return to the
time display If you should forget to press
this button, the display will return to time
display mode automatically after about 5
minutes
2 Upon total cuff deation, a series of
beeps are emitted and the ( ♥ ) symbol is
displayed