8
OPERATING INSTRUCTIONS
1. Before Operating Make sure all parts are mounted properly.
Check to fill the medication up to correct
level of 5 ml.
2. Plug In Connect the adapter into a standard AC 120V
outlet. Four (4) "AA" alkaline batteries may
also be used to run the unit.
3. Nebulizing Start the unit by pressing the ON/OFF button.
Continuous aerosol is controlled by holding the
button down for four (4) seconds. Press the
ON/OFF button again to turn off the unit.
NOTES:
A. The green operation light will be on during
continuous operation.
B. A blinking green light during battery power
means that the batteries are low and need to
be replaced as soon as possible.
4. Nebulization Rate The unit has been pre-set to nebulize at an aver-
age rate of 0.25 ml per minute. Nebulization
rates may vary due to different medications.
Check with your healthcare provider or
pharmacist regarding your medication.