Omron ne-c801 Respiratory Product User Manual


 
6
Important safety instructions
• Do not block the slit between the cap and the inhalation air inlet.
• Do not use a microwave oven or hair dryer to dry the nebulising parts.
• Approved for human use only.
• If the device is used continuously, the service life of the device may be shortened.
• Limit use to 20 minutes at a time, and allow a 40 minute interval before using the
device again.
• When using the device, the main unit may become hot.
• Do not touch the main unit for other than necessary operation such as turning off
the power while nebulising.
• To avoid the medication remains on the face, be sure to wipe the face after
removing the Mask.
(Risk of electrical shock)
• Always unplug the AC adapter from the power outlet after use and before cleaning.
• Plug the device into the appropriate voltage outlet. Do not overload power outlets
or use extension cords.
• Always remove the AC adapter from the device after use and before cleaning.
• Do not misuse the cord of the AC adapter.
• Do not wind the cord of the AC adapter around the compressor or AC adapter.
• Changes or modifications not approved by OMRON HEALTHCARE will void the
user warranty.
General Safety Precautions:
• Inspect the device and parts before using them each time, and check that there
are no problems. In particular, be sure to check the following:
- That the vaporiser head, nozzle or air tube are not damaged.
- That the nozzle is not blocked.
- That the compressor operates normally.
• When using this device, there will be some noise and vibration caused by the
pump in the compressor. There will also be some noise caused by the emission
of compressed air from the nebuliser kit. This is normal and does not indicate a
malfunction.
• Operate the device only as intended. Do not use the device for any other purpose.
• Do not use the device at temperatures greater than +40°C.
• Make sure that the air tube is securely attached to the compressor and nebuliser
kit, and does not come loose. Twist the air tube plug slightly when inserting it into
the air tube connectors to avoid the air tube disconnecting during use.
• The AC adapter is provided so that the device can be completely isolated from
the power source. To completely isolate the device from the power source unplug
the plug from the power source.
• Read and follow the “Correct Disposal of This Product” in the Technical Data
Section (page 28) when disposing of the device and any used accessories or
optional parts.
Save these instructions for future reference.
NE-C801S-E_M_main.book Page 6 Wednesday, January 11, 2012 12:35 PM