Filter
Top Products
10
Switching the device off
Press and hold the START button for more than 10 seconds then release it when
two horizontal segments appear on the LCD, this way the OMRON M24/7 will be
switched off. If you do not release the button in 2 seconds after the two horizontal
segments appeared, the monitor will return to normal operation. This feature helps
to avoid unintended power-off. The device can only be switched on manually.
While the monitor is switched off normal functions are not available, even
prescheduled measurements will not be triggered. Therefore, only in case
of a valid reason should the device be switched off.
Switching the device on
The OMRON M24/7 is switched on to normal operation if the START button is
pressed and held for more than 3 seconds. If the device is switched off, no other
functions are available.
LCD check
Press and hold the START button 3 to 5 seconds to light up all segments of the
LCD to check if they all work correctly.
Battery voltage check
Press and hold the START button for more than 5 seconds to display battery
voltage on the LCD (e.g. 2_37, equal to 2.37 V, see example). After checking
the voltage, please release the button, because after additional 5 seconds, the
device may turn off. The unit will then return to displaying time. The voltage for
fresh alkaline batteries should be over 3 V and for fully charged accumulators
over 2.5 V.
Set a patient event marker
The patient can mark any event without starting a manual blood pressure
measurement by pressing the EVENT button brieÀ y. A typical causes for this
use is taking medicine. The patient should be instructed to record the reason for
setting an event marker in a diary (see Patient’s Quick Guide and template for
patient diary at the end of this user manual).
Mark time of going to bed and rising from bed
If the DAY/NIGHT shift function is disabled during programming, the patient can
press the DAY/NIGHT button to mark the time of going to bed (in the evening)
and rising from bed (in the morning).
Manual DAY/NIGHT shift
If this function is enabled during the programming, then the patient can manually
shift the measurement frequency period (day or night) by pressing the DAY/NIGHT
button. The shift is available in the two hour period before the prescheduled shift.
IM_EN.indd 10 19/07/2012 14:30:02