Filter
Top Products
English
11
10
START
Continue to press button
➍
When the measurement is complete, the cuff
completely deflates and your blood pressure and
pulse rate are displayed.
NOTE :
The monitor automatically stores blood pressure
and pulse rate into the memory.
• When 28 sets of readings are stored in memory,
the oldest set will be deleted to store a new set.
➎
Press the (O/I) button to turn the monitor off.
NOTE :
If you forget to turn the monitor off, it will
automatically shut itself off after five minutes.
Instructions for special conditions:
• If your systolic pressure is known to be more than
220 mmHg, press and hold the (START ) button
until the monitor inflates 30 to 40 mmHg higher
than your suspected systolic pressure.
NOTE :
Do not apply more pressure than necessary.
The monitor will not inflate above 300 mmHg.
How to use the
memory
function
This monitor has a memory capable of storing 28
sets of readings. Every time you complete the
measurement, the monitor automatically stores blood
pressure and pulse rate.
• Turn on the monitor by pressing the (O/I) button.
• Press the ( ) button to recall stored readings
while the ( ) symbol is displayed.
START
Press these two buttons
at the same time.
• To delete all the stored readings, press the ( ) button
and the (START ) button simultaneously.
NOTE :
You can not delete the stored readings partially.
Date and Time of stored readings
will be alternately displayed.