Filter
Top Products
DESCRIPTION OF DISPLAY MARKS
Deflating
Inflating
Measurement error
Measuring
Low battery
PREPARATION BEFORE TAKING A MEASUREMENT
Battery installation:
- Pull off the battery cover in the
same direction as the arrows
are pointing.
- Install 2 pcs. alkaline AAA bat-
teries, noting the proper orien-
tation of positive and negative
terminals of the batteries in the
battery compartment.
- Replace the battery cover.
- If the low battery symbol
appears on the display replace
both batteries.
- It is recommended that you
use Alkaline batteries since
they are functioning for a lon-
ger period of time.
- Remove the batteries if the unit is not being used for a long peri-
od of time.
Applying the waste cuff:
- With your palm side up, center monitor on your wrist and apply
the cuff so that the cuff’s edge should be approximately 1 cm
from your palm.
- Do not apply wrist unit on top of a shirt sleeve.
- Wrap the cuff snugly around your wrist and attach using the
fastener. The top and bottom edges of the cuff should be tighten-
ded evenly around your wrist.
- Any gab between the wrist and cuff will affect the result of the
measurement.
- The fabric cuff can be folded down for ease of viewing the dis-
play.
TAKING A MEASUREMENT
- After the cuff has been properly placed on either the right or left
wrist, press the Start/Stop button. All symbols on the display will
appear.
- After the display reads "0" the "Fuzzy Logic function will auto-
matically inflate to an approximate pressure and will then begin to
slowly deflate as it takes the measurement. When the measure-
ment is done the heart symbol will be shown on the display and
the systolic and diastolic values be shown in the display after 5
sec. will the pulse be shown in the display. Now will the values be
43
MS-900VX IM new 01/10/03 9:54 Side 43 (Sort/Process Black plade)