Lowrance electronic LDT-3001 Thermometer User Manual


 
SENSOR CONNECTIONS
Mount the temperature sensor in a location that allows contact with the
water at all times. The illustration below shows a typical location. Once
a suitable place is found, mount the sensor to the hull with two #8 stainless
steel screws. (not included) Route the sensor cable to the 3001. Do not
cut the cable if it is too long! Coil and store it out of the way.
Attach the sensor wires to the 3001 using the supplied screws and
washers. Make certain to attach the sensor’s wires to the 3001 according
to the diagram shown below. If the wires are reversed, no damage to the
unit will occur, but it won’t work properly. The 3001 is now ready for use.
BLACK
12 VOLT
BATTERY
RED
WHITE
TO
TEMPERATURE
SENSOR
SENSOR'S
RED
WIRE
1-AMP
FUSE
POWER
SWITCH
LIGHT
SWITCH
SENSOR'S
SHIELD
WIRE
Note:
Light and
Power
Switches
Are Not
Included.
3