2 1/8" (54 mm) HOLE
2 1/2"
(64 mm)
(SQUARE
BEZEL)
2 3/8" ( 60 mm)
(ROUND
BEZEL)
1
The LDT-3001 is a digital temperature meter. It's operation is completely
automatic. There are no controls. This unit fits in a standard 2 1/8" (54
mm) hole used by most marine equipment manufacturers.
Mounting
This unit needs at least 2 1/2" (64 mm) of space to mount on any flat
panel or dash. To install the unit, also make certain there is at least 3 3/4"
(95 mm) from the front of the dash to any obstruction behind the dash.
Check to be sure there is room to route the power and sensor cables.
The maximum usable dash thickness is 1 1/8" (28.5 mm).
3 3/4" minimum
clearance
DASH
TIGHTEN
THESE
SCREWS
SCREW