Support User Manuals

Invacare TPO100 Oxygen Equipment User Manual

Open as PDF

of 52

SECTION 6—OPERATING INSTRUCTIONS

Invacare SOLO

2

™ 28 Part No 1156872

Mode & Flow Adjustment Screen

Thisscreenallowstheusertochangethecurrentmodeofoperationand

outputflow.Toaccessthisscreen,whenthetransportableoxygen

concentr atorisoperatingandeithertheNorma lOperatingscreenorthe

Standbyscreensare shown,pressandholdtheMode/Return/Highlight

button,Up/Increase,orDown/Decreasebutton forapproximately

2seconds

(screenshouldchangetoMode&FlowAdjust).

Saving Mode Changes

OncetheMode&Flowscreenisdisplayed,pressandholdtheMode/

Return/Highlightbuttonforonesecondtochangethemode.Waitforthe

screentoflashthreetimesforthechangestotakeeffect.Seethesectionon

Control/Adjustment

buttons.

Saving Flow Changes

OncetheMode&Flowscreenisdisplay ed,press andho ldtheUp/Increase,

orDown/Decreasebuttonuntildesiredsettingis achieved. Waitforthe

screentoflashthreetimesforthechangestotakeeffect.Seethesectionon

Control/Adjustmentbuttons.

LCD Adjustment Screen

Thisscreenisusedto adjustthebrightness

andcontrastoftheLCD.When

av ailabl e,thisscreencanalsobeusedtochangescreenlanguage.

FIGURE 6.7 LCD Adjustment Screen

Oncethisscreenisdisplayed,usetheMode/Return/Highlightandthe

Increase/Decreasebuttonstomovethehighlight barandmake ch anges.See

thesectiononControl/Adjustmentbuttons.

Saving Changes to LCD

Whenmakingchangestovaluesonthe

LCDAdjustmentscreenthechange

isstoredonlybyusingthereturn/highlightbuttontomovebackto

highlightingthesettingname.

Ifnobuttonispressedfor20secondsandthehighlightbarhasnotbeen

returnedtothesetting name,thedisplaywil lreturntotheNormal

Operatingscreenautomatically 

without savingthechange.

previous next