Filter
Top Products
SECTION 6—RIDING POSITION
Recumbent Handcycle Series 32 Part No 1114850
SECTION 6—RIDING POSITION
ƽ WARNING
After any adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Replacing/Adjusting the Footrest and Leg Guard
NOTE:Forthisprocedure,refertoFIGURE 6.1.
NOTE:Ifreplacingfootrestorlegguard,takenoteofcurrentposition.
Replacing/Adjusting Footrest
1. Removethehexboltandlocknutthat
securethefootresttothefork.
2. Ifreplacingfootrestperformthe
following:
A. Removeexistingfootrestfrom
clamp.
B. Insertnewfootrestintoclamp.
3. Slidefootresttodesiredposition.
4. Reinstallhexboltandlocknut.Tighten
securely.
5. RepeatSTEPS1‐5fortheopposite
footrest,ifnecessary.
Replacing/Adjusting Leg Guard
NOTE:ThisprocedureisforTopEndXLT,
XLTJr.,andXLTProONLY.
1. Loosenthetwoallenscrewsoneach
mountingclamp.
2. Ifreplacinglegguard,preformthe
following:
3. Removeexistinglegguardfrom
clamps.
4. Insertnewlegguardintoclamps.
FIGURE 6.1 Replacing/Adjusting the
Footrest and Leg Guard
5. Positioneachmountingclampontotheforkunderthebrake
cable.
NOTE:Thelegguardshouldsurround,butnottouch,therearofthefronttire.
6. Adjustlegguardtodesiredposition.
7. Tightenthetwoallenscrewsoneachmountingclampsecurely.
Fork
Clamp, Hex,
Bolt and
Locknut
Footrest
Footrest Replacement/Adjustment
Fork
Brake Cable
Leg Guard Replacement/Adjustment
Allen
Screws
Mounting
Clamp
Leg Guard
Rear of
Front Tire