Filter
Top Products
17
Square
Linkage
Rod
Linkage Rods
FIGURE 2 - ADJUSTING THE BASE
The casters MUST swivel and roll smoothly. A light grease
(waterproof auto lubricant) may be applied to the ball
bearing swivel of the casters once a year. Apply more
frequently if the casters are exposed to extreme moist con-
ditions.
WEAR AND DAMAGE
It is important to inspect all stressed parts, such as slings
and any attachment point for slings for signs of cracking,
fraying, deformation or deterioration. Replace any defective
parts immediately and ensure that the lift is not used until
repairs are made.
CLEANING
The sling should be washed regularly in water
temperature of 180
o
F (82
o
C) and a biological solution. A
soft cloth, dampened with water and a small amount of
mild detergent, is all that is needed to clean the stand up
lift. The lift can be cleaned with non-abrasive cleaners.
ADJUSTING THE BASE (FIGURE 2)
NOTE: The base adjustment should not require any
attention other than:
1. Check the squareness of the legs when in the
CLOSED position.
2. Place a square on the inside of the legs and base to
determine the 90
o
alignment.
3. Adjust the linkage rods until 90
o
alignment is achieved.
C
A
R
E
-
M
A
I
N
T
E
N
A
N
C
E
CARE AND MAINTENANCE OF YOUR STAND UP LIFT
FIGURE 1 - LUBRICATION
Lubricate the Bearings in the Caster Swivels
ADJUSTING THE KNEE PAD HEIGHT
(FIGURE 3)
FIGURE 3 - ADJUSTING THE KNEE PAD HEIGHT
Knee Pad
1. Pick a height setting that will be comfortable to the
patient and provide the necessary support.
NOTE: The knee pad should be positioned so that the
knee portion of the leg is in contact with the pad.
2. Using both hands, pull both adjustment pins outward
at the same time.
3. Position the knee pad to the desired height and release
adjustment pins into the corresponding alignment holes.
4. Check to make sure that both pins are engaged.
Adjustment Pin
Adjustment
Pin
WARNING
NEVER adjust knee pad while patient is in
the standing position.
NEVER try to adjust knee pad while the lift
is moving.
ALWAYS make sure that the adjustment pins
are engaged in corresponding height ad-
justment holes before using.