Invacare RPS350-1 Personal Lift User Manual


 
16
SYMPTOMS
FAULTS
SOLUTION
Needs lubrication.
Hand-control or actuator connector
loose.
RED emergency stop button
pressed IN.
Batteries low.
Battery not connected properly to
control box.
The connecting terminals are
damaged.
Electric actuator in need of service or
load is too high.
Actuator is worn or damaged or
spindle is bent.
Lift arms require a minimum weight
load to lower from the uppermost po-
sition.
Noisy or dry sound from pivots.
Electric actuator fails to lift when
button is pressed.
Unusual noise from actuator.
Lift arms will not lower in uppermost
position.
TROUBLESHOOTING (CONT.)
T
R
O
U
B
L
E
S
H
O
O
T
I
N
G
TROUBLESHOOTING / CARE AND MAINTENANCE OF YOUR STAND UP LIFT
NOTE: If problems are not remedied by the suggested means, please contact your Dealer or Invacare.
Refer to LUBRICATION in the CARE
AND MAINTENANCE section of this
manual.
Check connections.
Rotate RED emergency stop button
CLOCKWISE until it pops out.
Charge batteries. Refer to
CHARGING BATTERIES in the
OPERATION section of this manual.
Reconnect the battery to the control
box. Refer to CHARGING BATTE-
RIES in the OPERATION section of
this manual.
Replace the battery pack. Refer to
CHARGING BATTERIES in the OPE-
RATION section of this manual.
Refer to ELECTRIC ACTUATOR
REPLACEMENT in the CARE
AND MAINTENANCE section of
this manual. Contact your Dealer.
Refer to ELECTRIC ACTUATOR
REPLACEMENT in the CARE
AND MAINTENANCE section of
this manual. Contact your Dealer.
Pull down slightly on the lift arms.
CARE AND MAINTENANCE OF YOUR STAND UP LIFT
C
A
R
E
-
M
A
I
N
T
E
N
A
N
C
E
NOTE: Follow the maintenance procedures described in
this manual to keep your stand up lift in continuous service.
The Invacare Stand Up Lift is designed to provide a maxi-
mum of safe, efficient and satisfactory service with mini-
mum care and maintenance.
All parts of the Invacare Stand Up Lift are made of the best
grades of steel, but metal to metal contact will wear after
considerable use.
There is no adjustment or maintenance of either the cast-
ers or brakes, other than cleaning, lubrication and check-
ing axle and swivel bolts for tightness. Remove all debris,
etc. from the wheel and swivel bearings. If any parts are
worn, replace these parts immediately.
If you question the safety of any part of the lift, contact your
Dealer immediately and advise him/her of your problem.
LUBRICATION (FIGURE 1)
The Invacare Stand Up Lift is designed for minimum main-
tenance; however, a six (6) month check should ensure
continued safety and reliability.
Keep lift and slings clean and in good working order. Any
defect should be noted and reported to your dealer as
soon as possible.