Filter
Top Products
Invacare Scooters 52 Part No. 1090132 Rev F
TRANSPORT PROCEDURE 10
8. For Panther MX-4 Models Built Before 10/00 - Without Delta Tillers (FIGURE
3):
WARNING
When reassembling scooter, ensure retaining pin is properly engaged in
the hand brake cable. Otherwise, injury and/or damage may result.
A. Pull the retaining pin that secures the hand brake cable assembly together (DETAIL "A").
B. Remove the hand brake cable from the retaining tab located underneath the
front shroud (DETAILS "B" & "C").
NOTE: Note the position of the locknut in relation to the frame tab for proper reinstallation.
When re-assembling the hand brake cable assembly, the locknut must be positioned in front of
the frame tab (DETAILS "D" & "E").
C. Remove the threaded end of the hand brake cable from the frame tab of the rear sub-
frame.
Rear
Sub Frame
DETAIL "D" - REMOVING HAND
BRAKE CABLE
DETAIL "A"
Retaining Tab
Hand Brake Cable
Hand Brake
Cable Assembly
Retaining Pin
FIGURE 3 - TRANSPORTING THE SCOOTER - FOR PANTHER MX-4
MODELS BUILT BEFORE 10/00 - WITHOUT DELTA TILLERS
Threaded End
of Cable Assembly
Frame Tab of Rear
Sub-Frame
DETAIL "E" - INSTALLING HAND
BRAKE CABLE ASSEMBLY
Frame Tab
Threaded End
of Hand Brake
Cable Assembly
Locknut
NOTE: Side view shows location of Hand Brake Cable.
DETAIL "C" - HAND BRAKE
CABLE - SIDE VIEW
DETAIL "B"
Hand Brake Cable
Rear
Rear Wheel
TRANSPORT