Filter
Top Products
20
CALL TOLL FREE, 1-888-6AURORA
(628-7672)
QUESTIONS ABOUT THIS PRODUCT?
This Procedure Includes the Following:
Installing/Adjusting Anti-Tippers
Wheel Lock Adjustment
WARNING
After making adjustments, always
make sure that parts are properly tight-
ened BEFORE using the wheelchair.
INSTALLING
Anti-tipper
Release
Button
FIGURE 1 - INSTALLING/ADJUSTING
ANTI-TIPPERS
Spring Button
1-1/2 to 2-inch
Clearance
ADJUSTING
WHEEL LOCK ADJUSTMENT (FIGURE 2)
NOTE: Before adjusting or replacing the wheel lock as-
semblies, ensure that the tires are inflated to the recom-
mended psi on the side wall of the tire.
1. Loosen the two (2) allen screws that secure the wheel
lock assembly to the wheelchair frame.
NOTE: Any wheel lock adjustment should embed
the wheel lock shoe at least 3/16-inch into the tire
when engaged.
2. Adjust the position of wheel lock until the 3/16-inch
measurement is obtained for correct wheel lock ad-
justment.
3. Securely tighten the two (2) allen screws.
4. Engage the wheel lock and push against the wheel-
chair and determine if the wheel lock engages the
wheel lock shoe enough to hold the wheelchair.
5. Repeat the above procedures until the wheel lock holds
the wheelchair.
6. Repeat STEPS 1-5 for the opposite wheel lock.
W
H
E
E
L
L
O
C
K
S
A
N
T
I
T
I
P
P
E
R
S
INSTALLING/ADJUSTING
ANTI-TIPPERS (FIGURE 1)
WARNING
Anti-tippers are an option on this wheel-
chair. Invacare strongly recommends or-
dering the anti-tippers as an additional
safeguard for the wheelchair user.
Anti-tippers must be fully engaged and
spring button protruding out of locking
hole BEFORE using the wheelchair.
Installing the Anti-Tippers
1. Press the release buttons IN and insert the anti-tip-
pers with the anti-tipper wheels pointing toward the
ground/floor into the rear frame tubing until the but-
tons lock in place.
2. Measure the distance between the bottom of the anti-
tipper wheels and the ground/floor.
NOTE: a 1-1/2 to 2-inch clearance between the bottom of
the anti-tipper wheels and the ground/floor MUST be main-
tained at all times.
3. If the distance between the bottom of the anti-tipper
wheels and the ground/floor is not 1/1/2 to 2-inches,
adjust the anti-tippers. Refer to ADJUSTING THE
ANTI-TIPPERS in this section of the manual.
Adjusting the Anti-Tippers
1. Press the spring button on the wheeled portion of the
anti-tipper and slide it up or down to achieve the 1-1/2
to 2-inch clearance.
2. Check to make sure that the spring buttons are fully
engaged in adjustment holes.
ANTI-TIPPERS/WHEEL LOCKSPROCEDURE 6