Filter
Top Products
7
This Procedure Includes the Following:
Repair or Service Information
Operating Information
Safety/Handling of Wheelchairs
Warning/Caution Label Location - MWD Models
Warning/Caution Label Location - FWD Models
WARNING
CONTROLLER SETTINGS FOR RANGER II
JR
Set-up of the Electronic Control Unit is to be performed ONLY by a qualified technician. Factory setting
of the controller MUST be used for daily activities. Reprogramming the controller reduces the stability/
controllability of the wheelchair. Other program settings could cause the wheelchair to tip over result-
ing in serious injury to the user and/or damage to the surrounding property.
REPAIR OR SERVICE INFORMATION
Set-up of the Electronic Control Unit is to be performed ONLY by a qualified technician. The final tuning
adjustments of the controller may affect other activities of the wheelchair. Damage to the equipment
could occur under these circumstances. If any individual other than an a qualified technician per-
forms any work on these units, the warranty is void.
OPERATING INFORMATION
GENERAL WARNINGS
Performance adjustments should only be made by professionals of the healthcare field or persons fully
conversant with this process and the driver's capabilities. Incorrect settings could cause injury to the
driver, bystanders, damage to the chair and to surrounding property.
After the wheelchair has been set-up, check to make sure that the wheelchair performs to the speci-
fications entered during the set-up procedure. If the wheelchair does NOT perform to specifications,
turn the wheelchair OFF immediately and reenter set-up specifications. Repeat this procedure until the
wheelchair performs to specifications.
DO NOT shift your weight or sitting position toward the direction you are reaching as the wheelchair
may tip over.
DO NOT engage or disengage the motor locks/clutches until the power is in the OFF position.
DO NOT operate on roads, streets or highways.
DO NOT climb, go up or down ramps or traverse slopes greater than 9
o
.
DO NOT attempt to move up or down an incline with a water, ice or oil film.
DO NOT attempt to drive over curbs or obstacles. Doing so may cause your wheelchair to turn over
and cause bodily harm or damage to the chair.
DO NOT use parts, accessories, or adapters other than those authorized by Invacare.
DO NOT leave the power button ON when entering or exiting your wheelchair.
DO NOT stand on the frame of the wheelchair.
DO NOT use the footplates as a platform. When getting in or out of the wheelchair, make sure that the
footplates are in the upward position or swing footrests towards the outside of the chair.
ALWAYS wear your seat positioning strap.
TIRE PRESSURE
DO NOT use your wheelchair unless it has the proper tire pressure (P.S.I.). DO NOT overinflate the tires.
Failure to follow these suggestions may cause the tire to explode and cause bodily harm. The recom-
mended tire pressure is listed on the side wall of the tire.
G
E
N
E
R
A
L
G
U
I
D
E
L
I
N
E
S
GENERAL GUIDELINES PROCEDURE 1