Filter
Top Products
35
Battery Tray
Hex Bolt
FIGURE 2 - REPLACING BATTERY BOX RETAINING
STRAP - ALL FWD MODELS EXCEPT RANGER II
JR
All FWD Models Except RANGER II
JR
(FIGURE 2)
1. If necessary, remove the front and rear shrouds. Refer
to
REMOVING/INSTALLING SHROUDS in PROCE-
DURE 9 of this manual.
2. Remove the battery boxes from the wheelchair. Refer
INSTALLING/REMOVING BATTERY BOXES in
PROCEDURE 11 of this manual.
3. Remove the two (2) hex bolts and locknut that se-
cure the existing battery tray to the tray support.
4. Remove the existing battery tray from the wheelchair.
5. Position the new battery tray on the tray support as
shown in FIGURE 2.
6. Secure the new battery tray to the tray support with
the two (2) hex bolts and locknuts. Tighten securely.
7. Reinstall the battery boxes. Refer to
INSTALLING/
REMOVING BATTERY BOXES in PROCEDURE 11
of this manual.
8. If necessary, install the front and rear shrouds. Refer
to
REMOVING/INSTALLING SHROUDS in PROCE-
DURE 9 of this manual.
Tray Support
Locknut
R
E
T
A
I
N
I
N
G
S
T
R
A
P
PROCEDURE 7RETAINING STRAP