Support User Manuals

Invacare 9000 XT Mobility Scooter User Manual

Open as PDF

of 88

SECTION 7—RECLINER

9000 Series 60 Part No. 1076155

•Ifthereistoomuchplayinthereleasehandle:

i. Rotatethejamnutclockwise(downward)two(2)tothree(3)revolutions.

ii. Rotatetheswivelnutcounterclockwise(upward)one(1)revolution.

iii. Rotatethejamnutcounterclockwise(upward)directlyunderneaththeswivel

nut.Securelytighten.

iv. Squeezethereleasehandleandnotetheamountofplay.Ifnecessary,repeatthis

procedureuntiltheplayinthereleasehandleisatminimum.

•Ifthereisnotenoughplayinthereleasehandle:

i. Rotatethejamnutclockwise(downward)two(2)tothree(3)revolutions.

ii. Rotatetheswivelnutclockwise(downward)one(1)revolution.

iii. Rotatethejamnutcounterclockwise(upward)directlyunderneaththeswivel

nut.Securelytighten.

iv. Squeezereleasehandleandnotetheamountofplay.Ifnecessary,repeatthis

procedureuntilslightplayinthereleasehandleoccurs.

FIGURE 7.2 Adjusting Cable Assembly Tension

Replacing Cable Assembly

NOTE:Forthisprocedure,refertoFIGURE 7.3.

1. Cutthetie‐wrapsthatsecurethecableassemblytothebacktube.

2. Removethereleasehandle.RefertoReplacingReleaseHandle

onpage 58.

3. Disconnecttheexistinglowercableassembly.RefertoDisconnecting/Connecting

LowerCableAssemblyonpage 61.

Seven (7)

Threads

Back Tube

Mounting

Bracket

Release

Handle

Jam Nut

Swivel Nut

Cable

Assembly

previous next