Support User Manuals

Invacare 9000 XT Mobility Scooter User Manual

Open as PDF

of 88

SECTION 6—REAR WHEELS

9000 Series 52 Part No. 1076155

SECTION 6—REAR WHEELS

ƽ WARNING

After any adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely. Otherwise, injury or damage may occur.

NOTE:Exceptwherenoted,theproceduresinthissectionapplytonon‐reclinermodelsonly.For

reclinermodels,refertoReclineronpage 58.

Removing/Installing Rear Wheels

Quick-Release Axles

ƽ WARNING

NEVER use quick-release axles on the 9000 XT (models with offset axle option

only), 9000XDT or 9000XT recliner wheelchairs.

NOTE:Forthisprocedure,refertoFIGURE 6.1.

NOTE:Ifreplacingthesamesizerearwheel,notethemountingpositiononthewheelchairframe

forproperreinstallationofthenewrearwheel.

1. Pushinthedetentpinofthequick‐releaseaxle(withwheel)andpulltheaxleout

throughtheopeninginthecenteroftherearwheelandaxlespacer.

NOTE:Axlespacerisusedonlyifwheelchairisequippedwithconventionalarms.

2. Pushinthedetentpinofthequick‐releaseaxleagainandpulltheaxleoutoftherear

wheel.

3. RepeatSTEPS1‐2fortheoppositerearwheel.

4. Toreinstalltherearwheelontothewheelchair,reverseSTEPS1‐3.

NOTE:Makesureaxlespacerisbetweenrearwheelandwheelchairframeifwheelchairisequipped

withconventionalarms.

ƽ WARNING

Make sure the detent pin and detent balls of the quick-release axle are fully released

before operating the wheelchair.

The detent balls MUST be protruding past the inside of the rear wheel axle bushing

for a positive lock (Detail "A").

Keep detent balls clean.

Invacare recommends inserting quick-release axles with the detent pin to the inside

of the wheelchair to prevent accidental release during contact activities.

previous next