Invacare 9000 XT Mobility Aid User Manual


 
9000 Series 6 Part No. 1056953
IMPORTANT NOTICE
The wheel locks on this wheelchair have been
pre-set at the factory to comply with the
Veterans Administration functional Standard
8320.01 of the Federal Register, paragraph
3.2.4.5.3. If these wheel locks do not meet
your needs, follow instructions below.
!
CAUTION
Any wheel lock adjustments should embed
wheel lock shoe at least 1/8" into tire when
locked (3/16" on pneumatic tires).
INSTRUCTIONS FOR WHEEL
LOCK ADJUSTMENTS
1. Loosen wheel lock mounting fastener,
which runs through mounting bracket and
frame.
2. Slide clamp toward rear wheel until wheel
lock shoe is embedded into tire material at
least 1/8" when handle is engaged to the
lock position (3/16" for pneumatic tires).
3. Tighten mounting fastener to secure
mounting bracket in desired location and
recheck lock shoe embedding.
4. Inspect for correct locking action BEFORE
actual use.
00078X021-0394
LABEL LOCATIONS
LABEL LOCATIONS
LABEL LOCATIONS
WARNING
DO NOT OPERATE WITHOUT
THE ANTI-TIP TUBES
INSTALLED.
REV. 5/98
P/N 60106X144
WARNING
DETENT BALLS MUST BE SECURE-
LY SEATED IN RECESSED AREAS
OF AXLE BUSHINGS. ENSURE
THAT PLUNGER PIN IN HEAD END
OF AXLE IS FULLY RELEASED.
KEEP DETENT BALLS CLEAN.
1001948
MODELS WITH
QUICK-RELEASE
AXLES ONLY
Refer to Owner's Manual
for proper anti-tipper
setting.
1085379
WARNING
NOTE: On all anti-tippers
EXCEPT non-adjustable
anti-tippers.
CAUTION
SERVICE OF SPRING
LIFT MECHANISM TO
BE PERFORMED BY
PROPERLY TRAINED
AUTHORIZED SERVICE
PERSONNEL ONLY.
1022642
CAUTION
DO NOT recline without occupant. When the
chair is not occupied the back will raise abrup-
tly. Keep clear of the chair back when raising
or lowering to avoid injury.
1023096
9000 XT RECLINER MODELS ONLY
WARNING
DO NOT OPERATE WITHOUT
THE ANTI-TIP TUBES
INSTALLED.
REV. 5/98
P/N 60106X144
9000 XDT ONLY
Crossmember
Lower Frame
Tube