Support User Manuals

Invacare 1143199 Mobility Aid User Manual

Open as PDF

of 48

SECTION 2—INSTALLING

Part No 1143199 11 InTouch

™

Propel

™

Back

Installing/Removing the Propel Back

ƽ WARNING

The position of the Propel Back is directly related to the chair’s stability. It may be

necessary to reposition the front casters, rear wheels, back angle, and/or seat depth

before use. Use EXTREME caution when using a new seating position.

NOTE:Forthisprocedure,refertoFIGURE2.3onpage11.

NOTE:Toremovetheback,reversethisprocedure.

NOTE:IfthePropelBackdoesnotfitproperlyonthebackcanes,thebackwidthmayneedtobe

adjusted.RefertoAdjustingthePropelBackWidthonpage 12.

1. Alignthebacklatchbracketswiththetabsonthecanemountingbrackets.

2. Pushupthebacklatchesintotheunlockedposition.

NOTE:Thebacklatchesonthebacklatchbracketsmustbeintheup(unlocked)positiontoinstall

orremovethebackfromthewheelchair.

3. Installthebacklatchbracketsontothetabs.

NOTE:Ensurethebacklatchesrestflushonthetabs.

4. Pushthebacklatchesdown(lockedposition)tosecurethebacktothetabs.Referto

Detail“A ”ofFIGURE2.3.

5. Afterinstallationandbeforeuse,pulluponthebacktoensureitislocked.

FIGURE 2.3 Installing/Removing the Propel Back

DETAIL “A” - BACK LATCHES

Back

Cane

Mounting

Bracket

Cane

Mounting

Bracket

Back

Latch

Bracket

Tabs

Back

Latch

Back

Latch

Back

Latch

Bracket

previous next