Filter
Top Products
i
PREFACE
This manual describes the function, operation and maintenance of the
Maxtec Model OM-25A hand-held oxygen analyzer. A member of
Maxtec's MAXO
2 analyzer line of oxygen analyzers and monitors, the
OM-25A utilizes the MAX-250 oxygen sensor and is engineered for fast
response, maximum reliability and stable performance. The OM-25A is
designed primarily for spot-checking oxygen concentration delivered by
oxygen concentrator units, however, its internal sensor and adaptable
sampling port make it suitable for a wide variety of oxygen analysis
applications.
THANK YOU
Thank you for your purchase of a Maxtec MAXO2 oxygen analyzer. We
appreciate the time and energy you invest in selecting the equipment best
suited to your needs. As repayment, we are supplying you with a reliable,
high-quality instrument that, with proper care and operation, will provide
you with years of exceptional service. We also encourage your
comments or suggestions as to how our equipment, in any way, can
better serve your needs. Please feel free to write, FAX or e-mail us at the
address on the back of this manual c/o the Maxtec Marketing Department.
NOTE: In order to obtain optimum performance from your MAXO
2
analyzer, all operation and maintenance must be performed in
accordance with this manual. Please read the manual thoroughly
before using the analyzer and do not attempt any repair or
procedure that is not described herein. Maxtec cannot warrant any
damage resulting from misuse, unauthorized repair or improper
maintenance of the instrument.
WARNING
The sensor of the MAXO
2 Oxygen Analyzer (MAXO2) has been tested
with various anesthesia gases including Nitrous oxide, Halothane,
Isoflurane, Enflurane, Sevoflurane and Desflurane and found to have
acceptable low interferance, the device in its entirety (including
electronics) is not suitable for use in the presense of a flammable
anesthetic mixture. Only the threaded sensor face and sample inlet
connection may be allowed to contact such a gas mixture.
R213M15K.qxd 6/26/2006 8:59 AM Page i